IMG_9202

Step 5: Repeat previous steps, alternating between the 4mm and 6mm beads, until the barrette is finished. Complete the end with several more loops, pulled tightly into a coil (same as Step 1). Use pliers to clip off excess wire and trim any sharp ends.

Advertisements

RESIST ANY TENDENCY TO IMAGINE FUTURE JUDGEMENT UPON WORDS WHICH HAVE NOT BEEN WRITTEN YET

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s